Skip to content
Fast, Fair Plumbing in Edgeworth
Plumber reading the pressure gauge on a drain jetter

Drainage in Edgeworth

Hydro Jetting Edgeworth

Hydro jetting clears a drain with high-pressure water instead of a cable that pokes a hole through the problem.

For homes here, with clay pipes and big backyard trees, that is the difference between a drain that blocks again next month and one that stays clear. Plumbers Edgeworth has you covered for blocked drains, hot water, emergency plumbing and more, across the suburb and nearby areas like Cameron Park and Glendale.

If a drain keeps slowing down no matter how many times it has been cleared, jetting is usually the answer.

Call (02) 4063 3450 Get a quote
Two plumbers loading gear from the truck lockers

What hydro jetting actually does

The jetting side.

A jetter feeds a hose with a shaped nozzle into the pipe and fires water at very high pressure behind and ahead of it. That stream cuts roots, scours grease off the pipe wall, and sends silt down the line and out.

The old way.

An electric eel spins a cable with a cutting head. It opens a hole so water flows again, but the roots it cuts stay in the pipe and the grease on the walls stays too.

That is why an eel-cleared drain so often needs another visit within the year. Jetting leaves the pipe close to factory-clean, so there is far less for the next root tip or fat blob to grab onto.

Plumber clearing a stormwater pit with a jetter hose

When a drain needs jetting rather than a quick clear

Some blockages are simple and a basic clear does the job fine. Jetting earns its place when the drain has a history.

  • The same drain has been cleared two or three times and keeps slowing down again
  • Tree roots are the cause, which is common on the established blocks here
  • A kitchen line is choked with grease and food build-up rather than one solid lump
  • A stormwater line is half full of silt and garden debris after a wet season
  • You want the whole pipe cleaned, not just a tunnel through the middle

If the drain is actively backing sewage into the house, that is an emergency call first and a jetting job second. The emergency plumbing team handles the overflow side, and the burst pipes page covers what to do if water is going where it should not.

Why jetting suits the drains around here

The pipes are the era.

Most of this suburb grew through the 1960s to the 80s, when the old colliery land was carved up into brick-veneer family streets. The drainage that went in with those houses is vitrified clay and earthenware, and forty-plus years of ground movement has made those lines crack-prone at the joints.

Then the trees found them.

The mature trees on those established blocks send roots into every hairline crack in a clay joint. They thread through and grow into a root mass that catches everything passing by, and an eel leaves the fine root hairs stuck to the wall, which is all the invitation the next roots need.

Jetting shears that mass off flush with the pipe and flushes the lot away, which is why it is our default for root-blocked sewer lines around here.

Low ground adds a second problem.

On the flats near the Cockle Creek corridor, every big Hunter downpour washes silt and leaf litter into yard drains. Jetting clears that accumulation out properly rather than shifting it further along the line.

How the job runs

You get the same process on every job, and the price is agreed before any water goes through the pipe.

  1. 1

    Call and tell us

    Ring (02) 4063 3450 and tell us what's going on in Edgeworth. We'll ask a few quick questions so the right gear is on the truck the first time.

  2. 2

    Quote before work

    You get the price before anything starts. No call-out fee, no hourly surprises. You approve the quote or we shake hands and leave, no charge.

  3. 3

    Jet the line and confirm

    The right nozzle goes in for the pipe size and the blockage type, the line is scoured clean, and a camera run afterwards shows you the pipe open and flags any cracked joints or root entry points worth fixing.

  4. 4

    Backed, no questions asked

    If something isn't up to standard afterwards, we come back and make it right, no questions asked. That's the standard every Edgeworth job is held to.

That third step matters. Jetting without a camera afterwards is a half job, because you never learn whether the blockage was grease, roots through a joint, or a pipe about to collapse. The CCTV drain inspections page explains what the camera picks up.

What the price depends on

No two blocked drains cost the same to jet, and we put the figure in writing before we start. The main factors:

Which line it is

A kitchen waste line is quick access and quick work. A sewer main under the backyard or a stormwater run along the boundary takes longer to reach and clear.

What is in it

Grease and silt flush out fast. A mature root mass in a clay line takes longer and sometimes needs a cutting nozzle before the flushing one.

How bad the build-up is

A line cleared regularly jets in an hour or two. One that has been slowing for years carries years of scale.

Whether a camera runs before or after

It adds time but saves guesswork, especially on repeat offenders.

There is no call-out fee, so getting us to the door to look costs nothing.

Related drainage services

Jetting is one tool in the drainage kit, and sometimes it is not the whole answer.

  • Blocked drains covers the clearing service generally, including what causes repeat blockages
  • Blocked sewer deals with main line backups and surcharge inside the house
  • Blocked stormwater handles yard grates, downpipe lines and wet-weather flooding
  • The drainage hub gives the full picture of every drainage service on offer

If the problem is less about the drain and more about where the water is coming from, leak detection tracks down hidden leaks under slabs and inside walls.

Hydro jetting questions, answered

What is hydro jetting and how is it different from a drain machine?

A jetter fires high-pressure water through a nozzle and scours the entire pipe wall clean. A drain machine cuts a hole through the blockage but leaves grease and root hair behind.

Will jetting damage my old clay pipes?

Not when done properly. Pressure gets set to suit the pipe material, and older clay lines are worked around carefully. A camera run first shows anything fragile, and the approach changes accordingly.

Do you jet the drains of the suburbs around Edgeworth as well?

Yes. The regular run covers the neighbouring suburbs on the same trip, so a booking in Argenton, Cameron Park, Elermore Vale, Glendale or West Wallsend is a normal part of the week.

How long does a jetting job take?

A straightforward kitchen or sewer line usually takes a couple of hours on site. Lines full of tree roots take longer, and the realistic time gets spelled out in the quote.

Can jetting clear tree roots completely?

Jetting cuts roots flush with the pipe wall and washes the debris out. Roots through a cracked clay joint regrow in time, so the entry point gets shown along with the fix options.

Do I need a camera inspection before jetting?

Not always. An obvious grease blockage in a kitchen line can be jetted straight away. Repeat blockages or suspected root trouble get a camera run first, so the jetting is aimed properly.

Plumbers in Edgeworth and the suburbs around it

Book a jetting visit

Call (02) 4063 3450 and tell us what's happening. $0 call out across Edgeworth, a clear quote before any work starts, and a job that gets made right if it isn't right the first time.

Call us: (02) 4063 3450
Get a quote Call now